The capacity of the weld is then taken as double that of a single clip angle shear connection. Because no adequate methodology for the torsional strength of weld exists, the program will automatically place a weld on the bottom of the clip angles as well. When axial tension is present in the beam, the weld configuration of a single vertical weld on each clip angle (at the support) is inadequate, as that weld would have to resist the tension via torsion in the weld throat. The weld to beam is illustrated in Figure 10-4b of the AISC 14th Edition Manual. The weld to support is illustrated in Figure 10-4c of the AISC 14th Edition Manual. The geometries used are industry standard, and illustrated by the AISC. In order to make the connection property inputs easier these geometries may not be altered. The weld geometry for each connection is locked by the program. This topic is specific to welding geometry, base material strengths, weld strengths and all other welding considerations.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |